TC2050-XILINX: Adapter for use with Xilinx Platform Cable. ICs consist of logic cells, or boundary-scan cells, between the system logic and the signal pins or balls that connect the IC to the PCB. TC-Renesas: Adapter for Renesas E1/E2/E2 Lite/E8a/E20 Debuggers. The IEEE-1149.1 JTAG standard defines how IC scan logic must behave to achieve interoperability among components, systems, and test tools. TC-C2000 to TC2050 Adapter for use with TI DSP’s. Any loading circuitry should be buffered to avoid conflicts (for example, connecting ASSOCIATE / DIO5 to the gate of a MOSFET which drives the LED). TC-C2000 to TC2050 Adapter - Connection diagram. The following table indicates the JTAG signal name, the primary connection pin on the device, the secondary connection pin, and the secondary signal name.ĬAUTION! Do not load the secondary pins with circuitry that might interfere with JTAG programming (for example, an LED tied directly to the ASSOCIATE / DIO5 line). Three of these pins are also connected to a second pin on the device and are used for separate functions. There are four JTAG programming pins on the XBee/XBee-PRO Zigbee RF Module through which firmware can be loaded onto the EM357 processor. On the target board a male standard 20-pin double row connector (two rows of ten pins), pin-to-pin. Special instructions for using the JTAG interface The mechanical connector is specified by Arm (Arm-20).
0 kommentar(er)
